Huatao Group takes you to understand the safety operating regulations of bottle blowing machines
The knowledge of safe operation specifications of the bottle blowing machine includes the following points:
1. Before starting each shift, lubricating oil must be added to all moving parts. (Robot, robot guide rail, opening and closing mold guide rail)
2. The arm swing can be added once every (3-4) days. The large and small chains of the heating machine can be used once a month. Always check whether the main engine reducer and heating machine reducer are short of oil. The main engine bearings can be added once (2-3) months.
3. Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact force is strong, and whether the belt transmission part is abnormal.
4． Check whether the high-pressure air source, low-pressure air source, power supply, and water source are normal.
5. Check whether the emergency stop switch, safety door switch, and protection device detection switch are normal.
6． Check whether the embryo feeding and embryo removing parts of the heating head are working properly. If the embryo insertion is not in place, the nut of the embryo pressing device can be adjusted.
7. Check whether the lamp tube is damaged or broken. Replace in time.
8 . Check whether each pneumatic component is leaking and whether the action is sensitive.
9. Check whether the triplet is leaking abnormally, whether it is clogged, and whether the water storage capacity of the water cup is too full.
10. When the solenoid valve of the bottle blowing machine encounters an abnormality, it must be cleaned in time (cleaned once every 3.5 million bottles).
11. The bottle blowing mold must be cleaned and polished regularly.
12． When turning on the high and low pressure air source switch, you must move slowly to prevent the air source from flowing too fast and dirt blowing into the solenoid valve. At the same time, open the exhaust valve for 30 seconds to ensure clean air.
13. When starting the machine, the mechanical parts must be in good condition, there is no one inside the machine, and there are no foreign objects. Especially the position of the handle to avoid hurting people. Also close the safety door.
14. When starting the machine, you must first start the motor and delay starting the heating machine for 30 seconds to prevent voltage fluctuations. Before starting heating, make sure the cooling water is turned on.
15. After heating starts (2-3) minutes, wait until the oven temperature rises evenly, then press the embryo button. At the same time, the bottle blowing power must be turned on, otherwise the bottle will not be blown.
16. When the machine is running, you must pay close attention to whether there is any abnormal noise in the machine. It is necessary to detect it early and stop it in time to solve it.
17. In case of emergency, you can press the emergency stop button to apply the emergency brake. Then analyze the cause according to the on-site situation and find the problem to solve quickly.
18. After the machine is operating normally, do not extend any part of your body into the machine to avoid injury to the robot arm. If the machine makes abnormal noise, slow down and observe again.
19. After the machine is in normal production, the operator must always observe the quality of the bottles to prevent voltage fluctuations or other reasons from affecting the quality of the bottle blowing.
20. During machine maintenance, you can press the touch screen fault maintenance button to ensure safe maintenance.
HUATAO provides blow molding equipment. Including:
Plastic Mold Equipment
Automatic Blow Molding Machine
Semi-automatic Blow Molding Machine
PS Foaming Machine
EPE Foaming Machine
PU Foaming Molded Machine
Horizontal lnjection Molding Machine
vertical lnjection Molding Machine
All-electric Injection Molding Machine
Thick Sheet Blister Machine
Thin Sheet Blister Machine
Color Plastic Masterbatch
Plastic Recycle Machine
Whether you need help with equipment selection, process optimization, or design customization, our team can help. We have the expertise and knowledge to analyze your project needs, identify challenges and develop innovative solutions.